Epson EMP 7900 네트워크 매뉴얼 - 페이지 16

{카테고리_이름} Epson EMP 7900에 대한 네트워크 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson EMP 7900 43 페이지. Esc/vp21 command user's guide for business projectors
Epson EMP 7900에 대해서도 마찬가지입니다: 사양 (2 페이지), 사용자 설명서 (25 페이지), 사양 (4 페이지), 사용자 설명서 (25 페이지), 사용자 설명서 (28 페이지), 사용자 설명서 (28 페이지)

페이지 인쇄

Setting Up the Network Interface

Connecting the Network Interface to the Network

Follow the instructions below to connect the network interface to the network.

1. Make sure that your printer is turned off.

2. Connect one end of the network cable to the RJ-45 connector on the

network interface, and the other end to the network.

Caution:

❏ You must use a Category 5 shielded twisted-pair cable to connect the

network interface to prevent malfunction.

❏ Do not connect or disconnect the network cable when the printer is on.

Note:

You can use both 10Base-T and 100Base-TX. When you print a lot of data, we

recommend using the highest speed available for you product with light network

traffic.

3. Turn on your printer. After the status lights go off, print a network status

sheet.

Caution:

After turning off the printer, wait until the status lights go off before turning it

back on; otherwise the network interface may not work correctly.

Note for Mac OS X 10.4 or later:

Since the printer supports Bonjour/Rendezvous and is on by default, you can use

the printer on a network just by connecting it to the network. If you want to disable

the Bonjour/Rendezvous setting, use the printer's control panel. See "Setting an

IP Address on the Printer's Control Panel" on page 39 for details.

Now, you can configure the network interface to use TCP/IP on the network

and install the printer driver.

Setting Up Your System for Network Printing