Cisco 1600 series 매뉴얼 설치 또는 교체 - 페이지 6

{카테고리_이름} Cisco 1600 series에 대한 매뉴얼 설치 또는 교체을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1600 series 10 페이지. Rdiag router analog ipsec
Cisco 1600 series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (12 페이지), 빠른 시작 매뉴얼 (8 페이지), 하드웨어 설치 매뉴얼 (14 페이지)

페이지 인쇄

Replacing the Router Cover

Figure 5

Step 3

Caution

rear side; therefore, when you insert the SIMM, always use the polarization notch as a reference, not

the position of the components on the SIMM.

Step 4

Proceed with the next section "Replacing the Router Cover."

Replacing the Router Cover

Take the following steps to replace the router cover:

Step 1

Step 2

6 Installing or Replacing the DRAM SIMM in Cisco 1600 Series Routers

Replacing the DRAM SIMM

Pull the tabs away with

your thumbs, bracing your

forefingers against the

Connector edge of

posts. Raise the SIMM

the system card

to a vertical position.

DRAM SIMM card

With the rear panel of the router still facing you, position the new DRAM SIMM so that

the polarization notch is located at the right end of the SIMM socket.

To prevent damage, note that some DRAM SIMMs have the components mounted on the

Insert the new DRAM SIMM by sliding the end with the metal ﬁngers into the SIMM

socket at approximately a 45-degree angle to the system card. Gently rock the SIMM

back into place until the latch on either side snaps into place. Do not use excessive force

because the connector could break.

Align the top and bottom sections of the router.

Close the cover by slowly pressing the top and bottom sections together. (See Figure 6.)

Polarization notch