Cisco 1600 series 매뉴얼 설치 또는 교체 - 페이지 5

{카테고리_이름} Cisco 1600 series에 대한 매뉴얼 설치 또는 교체을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1600 series 10 페이지. Rdiag router analog ipsec
Cisco 1600 series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (12 페이지), 빠른 시작 매뉴얼 (8 페이지), 하드웨어 설치 매뉴얼 (14 페이지)

페이지 인쇄

Installing or Replacing the DRAM SIMM

Take the following steps to install or replace the DRAM SIMM:

Step 1

Figure 4

DRAM SIMM

Step 2

Caution

SIMM carefully.

If the router has a DRAM SIMM already installed, locate it on the system card. With the

rear panel of the router facing you, the DRAM SIMM is located in the upper left corner

of the system card, as shown in Figure 4. If there is no DRAM SIMM installed the router,

proceed to Step 3 to install a DRAM SIMM in the location shown in Figure 4.

DRAM SIMM Location—Cisco 1600 Series Routers

Remove any existing DRAM SIMM. While pulling outward on the tabs to unlatch them,

raise the SIMM to the vertical position and remove it from the SIMM socket.

(See Figure 5.)

To prevent damage, do not push on the center of the DRAM SIMM. Handle the DRAM

Installing or Replacing the DRAM SIMM in Cisco 1600 Series Routers

Installing or Replacing the DRAM SIMM

Rear panel of router