Epson EMP 810 네트워크 설치 매뉴얼 - 페이지 30

{카테고리_이름} Epson EMP 810에 대한 네트워크 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson EMP 810 37 페이지. Esc/vp21 command user's guide for business projectors
Epson EMP 810에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (17 페이지), 사용자 설명서 (24 페이지), 사양 (1 페이지), 사용자 설명서 (28 페이지)

Epson EMP 810 네트워크 설치 매뉴얼
Make sure there aren't any access restrictions (such as MAC address filtering)
set on the wireless router or access point. If access restrictions are set, register
the printer's MAC address on the router or access point. Print a Network
Status Sheet (see page 33) to obtain the MAC address. Then see your router or
access point's documentation for instructions.
If your wireless router or access point doesn't broadcast its network name
(SSID), see "Connect Wirelessly Using Advanced Setup" on page 8 for
instructions on connecting to your wireless network. If your wireless router or
access point has wireless security enabled, you will also need to know what
kind of security it is using.
If the printer doesn't connect to your wireless network, the WEP key or WPA
passphrase may have been entered incorrectly. See "Wireless Network
Installation" on page 4 to select your network settings again.
The printer is compatible with 802.11b and 802.11g. If your router or access
point supports 802.11n (Wireless N), makes sure that it is set to compatibility
mode to allow 802.11b and 802.11g devices to connect to it.
If your network has a firewall and you did not allow access when you installed
the software, you will need to reinstall the software following the instructions
on page 22. You might need to contact your firewall provider for assistance.
EpsonNet Setup was unable to find my printer on the network
1. If you see a screen like this one, click
30
Troubleshooting
and do one of the following:
OK