Epson EMP 810 Ağ Kurulum Kılavuzu - Sayfa 30

Projektör Epson EMP 810 için çevrimiçi göz atın veya pdf Ağ Kurulum Kılavuzu indirin. Epson EMP 810 37 sayfaları. Esc/vp21 command user's guide for business projectors
Ayrıca Epson EMP 810 için: Hızlı Referans Kılavuzu (17 sayfalar), Kullanıcı Kılavuzu (24 sayfalar), Teknik Özellikler (1 sayfalar), Kullanıcı Kılavuzu (28 sayfalar)

Epson EMP 810 Ağ Kurulum Kılavuzu
Make sure there aren't any access restrictions (such as MAC address filtering)
set on the wireless router or access point. If access restrictions are set, register
the printer's MAC address on the router or access point. Print a Network
Status Sheet (see page 33) to obtain the MAC address. Then see your router or
access point's documentation for instructions.
If your wireless router or access point doesn't broadcast its network name
(SSID), see "Connect Wirelessly Using Advanced Setup" on page 8 for
instructions on connecting to your wireless network. If your wireless router or
access point has wireless security enabled, you will also need to know what
kind of security it is using.
If the printer doesn't connect to your wireless network, the WEP key or WPA
passphrase may have been entered incorrectly. See "Wireless Network
Installation" on page 4 to select your network settings again.
The printer is compatible with 802.11b and 802.11g. If your router or access
point supports 802.11n (Wireless N), makes sure that it is set to compatibility
mode to allow 802.11b and 802.11g devices to connect to it.
If your network has a firewall and you did not allow access when you installed
the software, you will need to reinstall the software following the instructions
on page 22. You might need to contact your firewall provider for assistance.
EpsonNet Setup was unable to find my printer on the network
1. If you see a screen like this one, click
30
Troubleshooting
and do one of the following:
OK