Cisco 1700 series 매뉴얼 - 페이지 9

{카테고리_이름} Cisco 1700 series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1700 series 15 페이지. Secure firewall management center
Cisco 1700 series에 대해서도 마찬가지입니다: 규정 준수 및 안전 정보 매뉴얼 (45 페이지), 구성 매뉴얼 (25 페이지), 애플리케이션 노트 (41 페이지), 하드웨어 문제 해결 (12 페이지), 개요 매뉴얼 (13 페이지), 구성 (34 페이지), 매뉴얼 (5 페이지), 빠른 시작 매뉴얼 (6 페이지), 하드웨어 설치 매뉴얼 (46 페이지)

Appendix B

ROM Monitor

This will change the virtual configuration register to the value specified. The

value is always interpreted as hexadecimal. Entering confreg without an

argument displays the contents of the virtual configuration register and a prompt

to alter the contents by describing the meaning of each bit.

Whether or not an argument is provided, the new virtual configuration register

value is written into NVRAM, but it does not take effect until you reset or

power-cycle the router.

The following display shows an example of menu mode:

rommon 7> confreg

enabled are:

console baud: 9600

boot: the ROM Monitor

do you wish to change the configuration? y/n

enable

change console baud rate? y/n

enter rate: 0 = 9600, 1 = 4800, 2 = 1200, 3 = 2400

4 = 19200, 5 = 38400, 6 = 57600, 7 = 115200

change the boot characteristics? y/n

enter to boot:

0 = ROM Monitor

1 = the boot helper image

2-15 = boot system

Configuration Summary

enabled are:

diagnostic mode

console baud: 9600

boot: the ROM Monitor

do you wish to change the configuration? y/n

You must reset or power cycle for new config to take effect

78-5407-03

Configuration Summary

"diagnostic mode"? y/n

"use net in IP bcast address"? y/n

"load rom after netboot fails"? y/n

"use all zero broadcast"? y/n

"break/abort has effect"? y/n

"ignore system config info"? y/n

[0]:

Cisco 1700 Series Router Software Configuration Guide

[n]:

[0]:

[n]:

Configuration Register

B-9