Cisco 1802 빠른 시작 매뉴얼 - 페이지 7

{카테고리_이름} Cisco 1802에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1802 18 페이지. Integrated services routers cabling and installation
Cisco 1802에 대해서도 마찬가지입니다: 데이터시트 (16 페이지)

페이지 인쇄

1. Connecting the Router

Configuring the Router Using Cisco Router and Security Device Manager

Cisco Router and Security Device Manager (SDM) is a web-based configuration tool that allows you to configure LAN and

WAN interfaces, routing, Network Address Translation (NAT), firewalls, VPNs, and other features on your router. If SDM is

installed on your router, configure the router by following the instructions in the Cisco Router and Security Device Manager

(SDM) Quick Start Guide. If this document was not shipped with your router, you can obtain the SDM software and instructions

for installing it on your router from the following location:

http://www.cisco.com/pcgi-bin/tablebuild.pl/sdm

To obtain the SDM release notes and other SDM documentation, go to the following URL and click the Technical

Documentation link.

http://www.cisco.com/go/sdm

Connecting a PC to the Router Console Port

This step is optional; it is required only if you want to use the Cisco IOS CLI instead of SDM to configure or troubleshoot the

router. To use Cisco IOS, you must connect the router to a terminal or to a PC with terminal emulation software. Terminal

emulation software should be configured with the following settings:

• 9600 baud

• 8 data bits

• No parity bits

• 1 stop bit

The Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide describes how to configure the router

by using Cisco IOS software.

Follow these steps to connect the router to a terminal or PC:

Connect the RJ-45 end of the console cable to the CONSOLE port on the back panel of the router, as shown in Figure 4.

Step 1

Figure 4

Connecting the Console Cable to the Router

To PC

or Terminal 1

Connect the DB-9 end of the console cable to the console port (also called the serial port) on your PC. If this adapter

Step 2

does not fit your PC console port, you must provide an adapter that fits.