Cisco 1802 Посібник із швидкого старту - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мережевий маршрутизатор Cisco 1802. Cisco 1802 18 сторінок. Integrated services routers cabling and installation
Також для Cisco 1802: Технічний паспорт (16 сторінок)

Друкувати сторінку

1. Connecting the Router

Configuring the Router Using Cisco Router and Security Device Manager

Cisco Router and Security Device Manager (SDM) is a web-based configuration tool that allows you to configure LAN and

WAN interfaces, routing, Network Address Translation (NAT), firewalls, VPNs, and other features on your router. If SDM is

installed on your router, configure the router by following the instructions in the Cisco Router and Security Device Manager

(SDM) Quick Start Guide. If this document was not shipped with your router, you can obtain the SDM software and instructions

for installing it on your router from the following location:

http://www.cisco.com/pcgi-bin/tablebuild.pl/sdm

To obtain the SDM release notes and other SDM documentation, go to the following URL and click the Technical

Documentation link.

http://www.cisco.com/go/sdm

Connecting a PC to the Router Console Port

This step is optional; it is required only if you want to use the Cisco IOS CLI instead of SDM to configure or troubleshoot the

router. To use Cisco IOS, you must connect the router to a terminal or to a PC with terminal emulation software. Terminal

emulation software should be configured with the following settings:

• 9600 baud

• 8 data bits

• No parity bits

• 1 stop bit

The Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide describes how to configure the router

by using Cisco IOS software.

Follow these steps to connect the router to a terminal or PC:

Connect the RJ-45 end of the console cable to the CONSOLE port on the back panel of the router, as shown in Figure 4.

Step 1

Figure 4

Connecting the Console Cable to the Router

To PC

or Terminal 1

Connect the DB-9 end of the console cable to the console port (also called the serial port) on your PC. If this adapter

Step 2

does not fit your PC console port, you must provide an adapter that fits.