Cisco 1805 하드웨어 설치 매뉴얼 - 페이지 10

{카테고리_이름} Cisco 1805에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1805 12 페이지. Integrated services router
Cisco 1805에 대해서도 마찬가지입니다: 설치 및 교체 (4 페이지), 빠른 시작 매뉴얼 (4 페이지), 데이터시트 (10 페이지)

페이지 인쇄

Modules Internal to the Cisco 1805 Cable Router

Figure 8-10

Applying the AIM Label

The AIM label for the chassis might be in the AIM mounting kit, or it might be attached to the label on

the AIM card. Apply the chassis label as follows:

If the chassis label is attached to the label on the AIM card, carefully tear off the chassis label at the

Step 1

perforation. If the chassis label is in the AIM mounting kit, remove the label from the kit bag.

Peel the chassis label from its backing.

Step 2

If there is a suitable space, apply the chassis label to the back of the chassis. If no suitable space is

Step 3

available on the back of the chassis, apply the label to the top cover at the back edge. The label must be

visible with the chassis installed.

Note

Closing the Chassis

To close the chassis, follow these steps:

Rotate the cover down onto the chassis. Then slide the cover back onto the bottom of the chassis. See

Step 1

Figure

Push firmly to close.

Step 2

Turn the router upside-down.

Step 3

Cisco 1805 DOCSIS Cable Router Hardware Installation Guide

8-10

Correctly Installed AIM

Do not apply the AIM label for the chassis to a blank cover plate, to any removable network

module or interface card, or over any holes, screws, chassis vents, or existing labels.

8-11.

Chapter 8

Installing and Upgrading Internal Modules in Cisco 1805 Cable Routers

OL-14661-01