Cisco 1805 Instrukcja instalacji sprzętu - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja instalacji sprzętu dla Router sieciowy Cisco 1805. Cisco 1805 12 stron. Integrated services router
Również dla Cisco 1805: Instalacja i wymiana (4 strony), Skrócona instrukcja obsługi (4 strony), Arkusz danych (10 strony)
Drukuj stronę
Modules Internal to the Cisco 1805 Cable Router
Figure 8-10
Applying the AIM Label
The AIM label for the chassis might be in the AIM mounting kit, or it might be attached to the label on
the AIM card. Apply the chassis label as follows:
If the chassis label is attached to the label on the AIM card, carefully tear off the chassis label at the
Step 1
perforation. If the chassis label is in the AIM mounting kit, remove the label from the kit bag.
Peel the chassis label from its backing.
Step 2
If there is a suitable space, apply the chassis label to the back of the chassis. If no suitable space is
Step 3
available on the back of the chassis, apply the label to the top cover at the back edge. The label must be
visible with the chassis installed.
Note
Closing the Chassis
To close the chassis, follow these steps:
Rotate the cover down onto the chassis. Then slide the cover back onto the bottom of the chassis. See
Step 1
Figure
Push firmly to close.
Step 2
Turn the router upside-down.
Step 3
Cisco 1805 DOCSIS Cable Router Hardware Installation Guide
8-10
Correctly Installed AIM
Do not apply the AIM label for the chassis to a blank cover plate, to any removable network
module or interface card, or over any holes, screws, chassis vents, or existing labels.
8-11.
Chapter 8
Installing and Upgrading Internal Modules in Cisco 1805 Cable Routers
OL-14661-01