Cisco 2504 시작하기 매뉴얼 - 페이지 27

{카테고리_이름} Cisco 2504에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2504 47 페이지. Wireless controller
Cisco 2504에 대해서도 마찬가지입니다: 사용자 설명서 (11 페이지)

페이지 인쇄
Cisco 2504 시작하기 매뉴얼
Table 3
Wizard Setting
Enter Country Code List
Enable 802.11b Network
Enable 802.11a Network
Enable 802.11g Network
Enable Auto-RF
Configure a NTP server now?
Enter the NTP server IP address
Enter a polling interval between 3600 and 604800
secs
Configuration correct?

Logging into the Controller

To log into the 2504 controller, follow these steps:
Step 1
Enter a valid username and password to log into the controller CLI.
Step 2
The CLI displays the root level system prompt:
Startup Wizard Information (continued)
Note
The administrative username and password you created in the startup wizard are case
sensitive.
#(system prompt)>
The system prompt can be any alphanumeric string up to 31 characters. You can change it by
entering the config prompt command. For example, to change the system prompt to
CISCO2504, enter config prompt "CISCO2504" and press Enter. Make sure you enter the new
prompt using double quotation marks.
Action
Enter the two letter country code. The default country code is
the United States (US). Enter 'help' to see a list of countries.
Choose YES to enable or no to disable the 802.11b radio
network. The default is YES.
Choose YES to enable or no to disable the 802.11a radio
network. The default is YES.
Choose YES to enable or no disable the 802.11g radio
network. The default is YES.
Choose YES to enable or no to disable radio resource
management. The default is YES.
Enter YES to configure an NTP server. The values are YES or
no. The default value is YES.
Enter the NTP server IP address.
This prompt only displays if YES was entered in the
Note
"Configure a NTP Server Now?" prompt.
Enter the polling interval between 3600 and 604800 seconds.
Note
This prompt only displays if YES was entered in the
"Configure a NTP Server Now?" prompt.
Enter yes if the configuration entered is correct. Values are yes
and no. If yes is entered. the controller saves your
configuration, reboots, and prompts you to log in.
Cisco 2500 Series Wireless Controller Getting Started Guide
Logging into the Controller
27