Cisco 2504 시작하기 매뉴얼 - 페이지 28

{카테고리_이름} Cisco 2504에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2504 47 페이지. Wireless controller
Cisco 2504에 대해서도 마찬가지입니다: 사용자 설명서 (11 페이지)

Connecting to the Network

Figure 13

connection uses 10/100/1000BASE-T Ethernet (RJ-45 physical port, UTP, Category-5 or higher cable).

Always use Category-5, Category-5e, Category-6, or Category-7 Ethernet cables to connect the office

network equipment to the controller.

Figure 13

If the link does not activate, check the cable. When you are connecting to a hub or a switch, use a

Note

straight-through cable.

After you have configured the controller, use Category-5, Category-5e, Category-6, or Category-7

Ethernet cables to connect up to 50 Cisco lightweight access points to the controller Ethernet ports or to

the network (distribution system) as shown in

can use an MDI-X or MDI cable (crossover or straight-through) to make the connections.

As soon as the controller is operational, the controller is available to connect access that are scanning

for a controller. When it detects an access point, it records the access point MAC address in its database.

The controller Radio Resource Management (RRM) feature automatically configures the access point to

start transmitting and allowing clients to associate.

Cisco 2500 Series Wireless Controller Getting Started Guide

The CLI automatically logs out without saving any changes after 5 minutes of inactivity. You

Note

can set the automatic logout from 0 (never log out) to 160 minutes using the config serial

timeout command.

shows the connection from the network (802.11 distribution system) to the controller. The

External Network Equipment Connection to the Controller

Network

Connection to

main office

10/100/1000BASE-T

Firewall

Office

network

10/100/1000BASE-T

MDI cable

Figure

14. The controller has an auto MDI feature, so you

Cisco

Access Points

MDI cable

CLI console