Cisco 2524 - Router - EN 구성 매뉴얼 - 페이지 14

{카테고리_이름} Cisco 2524 - Router - EN에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2524 - Router - EN 23 페이지. Troubleshooting guide
Cisco 2524 - Router - EN에 대해서도 마찬가지입니다: 구성 매뉴얼 (23 페이지), 개요 (10 페이지), 설치 준비 (19 페이지), 문제 해결 매뉴얼 (4 페이지)

페이지 인쇄

Configuring the Router

Conﬁguring ISDN

If you have an ISDN BRI WAN module, conﬁgure the BRI port for ISDN. This section

explains typical ISDN conﬁgurations for one or two B channels. In the examples that

follow, the BRI port is conﬁgured for IP routing, Challenge Handshake Authentication

Protocol (CHAP), and Point-to-Point Protocol (PPP) encapsulation.

Take the following steps to conﬁgure the router for a basic ISDN PPP connection on a

single B channel or two B channels, substituting the correct addresses and host names as

appropriate for your network:

Step 1

Step 2

Note

the router to which the ISDN connection will be made. The username and password are

case sensitive.

Step 3

4-14 Cisco 2524 and Cisco 2525 Router User Guide

Enter enable mode:

Router> enable

password: enablepassword

Enter the conﬁgure terminal command. Then enter the host name and password

that the router will use for CHAP caller identiﬁcation:

Router# config term

Router (config)# username targetrouter password abc

The username and password must match the username and password already set on

If you have not already done so, enter the isdn switch-type command to conﬁgure

the ISDN switch type:

router (config)# isdn switch-type switch-type

Refer to Table 4-1 earlier in this chapter for a list of ISDN switch types.