Cisco 2524 - Router - EN Yapılandırma Kılavuzu - Sayfa 14
Ağ Yönlendiricisi Cisco 2524 - Router - EN için çevrimiçi göz atın veya pdf Yapılandırma Kılavuzu indirin. Cisco 2524 - Router - EN 23 sayfaları. Troubleshooting guide
Ayrıca Cisco 2524 - Router - EN için: Yapılandırma Kılavuzu (23 sayfalar), Genel Bakış (10 sayfalar), Kuruluma Hazırlanıyor (19 sayfalar), Sorun Giderme Kılavuzu (4 sayfalar)
Sayfayı Yazdır
Configuring the Router
Configuring ISDN
If you have an ISDN BRI WAN module, configure the BRI port for ISDN. This section
explains typical ISDN configurations for one or two B channels. In the examples that
follow, the BRI port is configured for IP routing, Challenge Handshake Authentication
Protocol (CHAP), and Point-to-Point Protocol (PPP) encapsulation.
Take the following steps to configure the router for a basic ISDN PPP connection on a
single B channel or two B channels, substituting the correct addresses and host names as
appropriate for your network:
Step 1
Step 2
Note
the router to which the ISDN connection will be made. The username and password are
case sensitive.
Step 3
4-14 Cisco 2524 and Cisco 2525 Router User Guide
Enter enable mode:
Router> enable
password: enablepassword
Enter the configure terminal command. Then enter the host name and password
that the router will use for CHAP caller identification:
Router# config term
Router (config)# username targetrouter password abc
The username and password must match the username and password already set on
If you have not already done so, enter the isdn switch-type command to configure
the ISDN switch type:
router (config)# isdn switch-type switch-type
Refer to Table 4-1 earlier in this chapter for a list of ISDN switch types.