Cisco 2610 - Router - EN 빠른 시작 매뉴얼 - 페이지 7
{카테고리_이름} Cisco 2610 - Router - EN에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2610 - Router - EN 19 페이지. Cisco 2610: quick start
Cisco 2610 - Router - EN에 대해서도 마찬가지입니다: 데이터시트 (8 페이지)
페이지 인쇄2
Connect Cables (continued)
MODEMS
16AM
15
14
13
12
11
IN USE
7
6
5
4
3
Analog modem
port (RJ-11)
RJ-11 modem cable
Connect the Modem Cables
The Cisco 2610 router comes with an 8- or 16-port
internal analog modem module. Use these ports to
connect up to 16 modems.
12
Timesaver
Start by connecting only one
9
3
modem. After you have configured the
6
router settings for this modem and
completed the procedure on page 9
successfully, connect and set up the
remaining modems.
1
Connect one end of the pink modem cable to one
of the numbered modem ports (also pink) on the
router's rear panel.
2
Connect the other end of the pink modem cable
to an RJ-11 telephone wall jack or an RJ-11
outlet in your wiring closet.
10
9
8
IN USE
SERIAL 1
SERIAL 0
CONN
WIC
CONN
2A/S
CONN
SEE MANUAL BEFORE INSTALLATION
2
1
0
EN
SEE MANUAL BEFORE INSTALLATION
LINK
ETHERN ET 0
CONSOL E
RJ-11 jack
SERIAL 1
100-240V – 1A
50/60 Hz
47 W
SERIAL 0
WIC
CONN
2T
AUX
If you followed the suggestion, in the Timesaver
section on this page, and only connected one cable,
you will have to connect the remaining modem
cables after you configure and test the router. See
page 10, for information on how to finish the
cabling.
7