Cisco 2950 - Catalyst Switch 시작하기 매뉴얼 - 페이지 19

{카테고리_이름} Cisco 2950 - Catalyst Switch에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2950 - Catalyst Switch 29 페이지. Long-reach ethernet switches
Cisco 2950 - Catalyst Switch에 대해서도 마찬가지입니다: 솔루션 매뉴얼 (17 페이지), 제품 게시판 (3 페이지), 제품 지원 게시판 (5 페이지), 마이그레이션 매뉴얼 (25 페이지), 제품 지원 게시판 (6 페이지), 데이터시트 (20 페이지), 매뉴얼 (19 페이지)

페이지 인쇄

In Case of Difficulty

If you experience difficulty, help is available here and on Cisco.com. This section includes Express

Setup troubleshooting, how to reset the switch, how to access help online, and where to find more

information.

Troubleshooting Express Setup

If Express Setup does not run, or if the Express Setup page does not appear in your browser:

• Did you verify that POST successfully ran

before starting Express Setup?

• Did you press the Mode button while the

switch was still running POST?

• Did you try to continue without confirming

that the switch was in Express Setup mode?

• Does your PC have a static IP address?

• Did you connect a crossover cable instead of

a straight-through Ethernet cable between a

switch port and the Ethernet port of the PC?

• Did you connect the Ethernet cable to the

console port instead of to a 10/100 or

10/100/1000 Ethernet port on the switch?

If not, make sure that only the SYST and STAT

LEDs are green before pressing the Mode button

to enter the Express Setup mode.

If yes, wait until POST completes. Power cycle the

switch. Wait until POST completes. Confirm that

the SYST and STAT LEDs are green. Press the

Mode button to enter Express Setup mode.

Verify that all LEDs above the Mode button are

green. (The RPS LED is off.) If necessary, press

the Mode button to enter Express Setup mode.

If yes, before connecting to the switch, change

your PC settings to temporarily use DHCP.

If yes, connect a straight-through cable to an

Ethernet port on the switch and the PC. Wait 30

seconds before entering 10.0.0.1 in the browser.

If yes, disconnect from the console port. Connect

to an Ethernet port on the switch and the PC.

Wait 30 seconds before entering 10.0.0.1 in the

browser.