Cisco 2950 - Catalyst Switch 매뉴얼 - 페이지 13

{카테고리_이름} Cisco 2950 - Catalyst Switch에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2950 - Catalyst Switch 19 페이지. Long-reach ethernet switches
Cisco 2950 - Catalyst Switch에 대해서도 마찬가지입니다: 솔루션 매뉴얼 (17 페이지), 제품 게시판 (3 페이지), 제품 지원 게시판 (5 페이지), 마이그레이션 매뉴얼 (25 페이지), 제품 지원 게시판 (6 페이지), 시작하기 매뉴얼 (29 페이지), 데이터시트 (20 페이지)

페이지 인쇄
Cisco 2950 - Catalyst Switch 매뉴얼
Cisco - Connecting a Terminal to the Console Port on Catalyst Switches
Switch
RJ45-to-RJ45
Console
Rollover Cable
(DTE)
RJ45
Signal
Pin
RTS
1¹
DTR
2
TxD
3
GND
4
GND
5
TxD
6
DSR
7
CTS
8¹
¹Pin 1 is connected internally to Pin 8.

Configuring a Terminal for Attachment to the Console or RSFC Port

Note: The console port is an asynchronous (Async) serial port; any device connected to this port must be
capable of asynchronous transmission.
Before connecting the console port, check the terminal documentation to determine the baud rate. The
baud rate of the terminal must match the default baud rate (9600 baud) of the console port. Set up the
terminal as follows:
9600 baud
8 data bits
No parity
1 stop bit
Connecting a Terminal to the Catalyst 4000
Supervisor Engine I Console Port
The console port, shown in the figure below, is a data communications equipment (DCE) DB-25
receptacle that supports a DCE EIA/TIA-232 interface. EIA/TIA-232 supports unbalanced circuits at
signal speeds up to 64 kbps.
Figure: DCE DB-25 Connector
http://www.cisco.com/warp/public/473/9.html (13 of 19) [9/4/2003 12:36:03 PM]
RJ45-to-DB25
Adapter
RJ45
DB25 Pin
Pin
8
5
7
6
6
3
5
7
4
7
3
2
2
20
1
4
Terminal
(DTE)
Signal
CTS
DSR
RxD
GND
GND
TxD
DTR
RTS