Cisco 2950 - Catalyst Switch Handmatig - Pagina 13

Blader online of download pdf Handmatig voor {categorie_naam} Cisco 2950 - Catalyst Switch. Cisco 2950 - Catalyst Switch 19 pagina's. Long-reach ethernet switches
Ook voor Cisco 2950 - Catalyst Switch: Oplossingshandleiding (17 pagina's), Product Bulletin (3 pagina's), Product ondersteunings bulletin (5 pagina's), Handboek migratie (25 pagina's), Product ondersteunings bulletin (6 pagina's), Aan de slag handleiding (29 pagina's), Gegevensblad (20 pagina's)

Pagina afdrukken
Cisco 2950 - Catalyst Switch Handmatig
Cisco - Connecting a Terminal to the Console Port on Catalyst Switches
Switch
RJ45-to-RJ45
Console
Rollover Cable
(DTE)
RJ45
Signal
Pin
RTS
1¹
DTR
2
TxD
3
GND
4
GND
5
TxD
6
DSR
7
CTS
8¹
¹Pin 1 is connected internally to Pin 8.

Configuring a Terminal for Attachment to the Console or RSFC Port

Note: The console port is an asynchronous (Async) serial port; any device connected to this port must be
capable of asynchronous transmission.
Before connecting the console port, check the terminal documentation to determine the baud rate. The
baud rate of the terminal must match the default baud rate (9600 baud) of the console port. Set up the
terminal as follows:
9600 baud
8 data bits
No parity
1 stop bit
Connecting a Terminal to the Catalyst 4000
Supervisor Engine I Console Port
The console port, shown in the figure below, is a data communications equipment (DCE) DB-25
receptacle that supports a DCE EIA/TIA-232 interface. EIA/TIA-232 supports unbalanced circuits at
signal speeds up to 64 kbps.
Figure: DCE DB-25 Connector
http://www.cisco.com/warp/public/473/9.html (13 of 19) [9/4/2003 12:36:03 PM]
RJ45-to-DB25
Adapter
RJ45
DB25 Pin
Pin
8
5
7
6
6
3
5
7
4
7
3
2
2
20
1
4
Terminal
(DTE)
Signal
CTS
DSR
RxD
GND
GND
TxD
DTR
RTS