Cisco 2950 - Catalyst Switch Handmatig - Pagina 12

Blader online of download pdf Handmatig voor {categorie_naam} Cisco 2950 - Catalyst Switch. Cisco 2950 - Catalyst Switch 19 pagina's. Long-reach ethernet switches
Ook voor Cisco 2950 - Catalyst Switch: Oplossingshandleiding (17 pagina's), Product Bulletin (3 pagina's), Product ondersteunings bulletin (5 pagina's), Handboek migratie (25 pagina's), Product ondersteunings bulletin (6 pagina's), Aan de slag handleiding (29 pagina's), Gegevensblad (20 pagina's)

Pagina afdrukken

Cisco - Connecting a Terminal to the Console Port on Catalyst Switches

Console Port Mode Switch

The console port mode switch allows you to connect either a terminal (DTE) or a modem (DCE)

depending on the mode that is selected and the cable that you are using.

Note: The cable and adapters shipped with the Supervisor Module II G and Supervisor Module III G are

the same ones used on the Cisco 2500 series routers (and other Cisco products).

Use the console port mode switch as follows:

Mode 1: Press to the in position. Use this mode to connect a terminal to the port using the console

cable and DTE adapter (labeled "Terminal") that shipped with the Supervisor Engine. You may

also use this mode to connect a modem to the port using the console cable and the DCE adapter

(labeled "Modem") that shipped with the switch.

Mode 2: Depress to the out position. Use this mode to connect a terminal to the port using the

Supervisor Engine III console cable (not provided).

Figure: EIA/TIA-232 RJ-45 Adapter Cable Connector

Table F-1: Console Port Signaling and Cabling Using a DB9 Adapter

Switch

RJ45-RJ45

Console

Rollover Cable

(DTE)

RJ45

Signal

RTS

1¹

DTR

TxD

GND

RxD

DSR

CTS

8¹

¹Pin 1 is connected internally to Pin 8.

Table F-2: Console Port Signaling and Cabling Using a DB25 Adapter

http://www.cisco.com/warp/public/473/9.html (12 of 19) [9/4/2003 12:36:03 PM]

RJ45-to-DB9

Adapter

RJ45

DB9 Pin

Terminal

(DTE)

Signal

CTS

DSR

RxD

GND

TxD

DTR

RTS