Cisco 3640 Series 빠른 시작 매뉴얼 - 페이지 28

{카테고리_이름} Cisco 3640 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3640 Series 37 페이지. Rack-mount and wall-mount
Cisco 3640 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (10 페이지), 소유자 매뉴얼 (17 페이지), 사용자 설명서 (26 페이지), 매뉴얼 (10 페이지), 구성 참고 사항 (18 페이지)

페이지 인쇄

1. Perform Initial Configuration

Step 1

To proceed using the setup command facility, enter yes.

Would you like to enter the initial configuration dialog? [yes/no]: yes

Step 2

When the following messages appear, press Return to enter basic management setup:

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Basic management setup configures only enough connectivity

for management of the system, extended setup will ask you

to configure each interface on the system

Would you like to enter basic management setup? [yes/no]: yes

Step 3

Enter a host name for the router (this example uses 3600):

Configuring global parameters:

Enter host name [Router]: 3600

The enable secret is a password used to protect access to privileged EXEC and configuration modes. This

password, after entered, becomes encrypted in the configuration.

Step 4

Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when viewing the

configuration:

Enter enable secret: xxxx

The enable password is used when you do not specify an enable secret password, with some older software

versions, and some boot images.

Enter an enable password that is different from the enable secret password. This password is not encrypted (less secure)

Step 5

and can be seen when viewing the configuration:

Enter enable password: xxxx

The virtual terminal password is used to protect access to the router over a network interface.

Step 6

Enter the virtual terminal password, which prevents unauthenticated access to the router through ports other than the

console port:

Enter virtual terminal password: xxxx

Step 7

Respond to the following prompts as appropriate for your network:

Configure SNMP Network Management? [yes]: yes

Community string [public]:

Step 8

A summary of the available interfaces is displayed.

Note

The interface numbering that appears is dependent on the type of Cisco modular router platform and on the

installed interface modules and cards.

Current interface summary

Any interface listed with OK? value "NO" does not have a valid configuration

Interface

FastEthernet0/0

FastEthernet0/1

Step 9

Select one of the available interfaces for connecting the router to the management network:

Enter interface name used to connect to the

management network from the above interface summary: fastethernet0/0

IP-Address

OK? Method Status

unassigned

unset

unassigned

unset

Protocol

down