Cisco 3640 Series 빠른 시작 매뉴얼 - 페이지 30

{카테고리_이름} Cisco 3640 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3640 Series 37 페이지. Rack-mount and wall-mount
Cisco 3640 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (10 페이지), 소유자 매뉴얼 (17 페이지), 사용자 설명서 (26 페이지), 매뉴얼 (10 페이지), 구성 참고 사항 (18 페이지)

페이지 인쇄

1. Perform Initial Configuration

Initial Configuration Using the CLI (Manual Configuration)

This section shows how to bring up a command-line interface (CLI) prompt for configuration using the CLI, and it directs you

to documentation for the CLI configuration.You can use the CLI if you see the following messages at the end of the startup

sequence:

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Would you like to enter the initial configuration dialog? [yes/no]:

If these messages do not appear, SDM and a default configuration file have been installed on the router at the factory. To use

SDM to configure the router, see the "Initial Configuration Using Cisco Router and Security Device Manager" section on

page 24.

Step 1

To proceed with manual configuration using the CLI, enter no.

Would you like to enter the initial configuration dialog? [yes/no]: no

Step 2

Press Return to terminate autoinstall and continue with manual configuration.

Would you like to terminate autoinstall? [yes] Return

Several messages are displayed, ending with a line similar to the following:

...

Compiled < date > < time > by < person >

Step 3

Press Return to bring up the

...

flashfs[4]: Initialization complete.

Router>

Step 4

Enter privileged EXEC mode.

Router> enable

Router#

Note

To avoid losing work you have completed, be sure to save your configuration occasionally as you proceed. Use the

copy running-config startup-config command to save the configuration to NVRAM.

For configuration using the CLI, refer to the applicable configuration procedures in the Software Configuration Guide:

Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers. See the "Where to Go Next" section on page 32 for

information about accessing this document.

prompt.

Router>