Epson EMP-TS10 설정 매뉴얼 - 페이지 13

{카테고리_이름} Epson EMP-TS10에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson EMP-TS10 22 페이지. Home theatre projector
Epson EMP-TS10에 대해서도 마찬가지입니다: 운영 매뉴얼 (36 페이지), 사양 (1 페이지), 포장 풀기 및 설치 매뉴얼 (2 페이지)

페이지 인쇄
Epson EMP-TS10 설정 매뉴얼
4
The projector cannot be connected to some types of computer, or projection of images
may not be possible even if actual connection is possible. Make sure that the computer
you intend to use satisfies the conditions given below.
Condition 1: The computer must have a image signal output port.
Check that the computer has a port such as an RGB port, monitor port or CRT port which
can output image signals. If the computer has a built-in monitor, or if using a laptop
computer, it may not be possible to connect the computer to the projector, or alternatively
you may need to purchase a separate external output port. Refer to the documentation for
your computer under a heading such as "Connecting an external monitor" or similar for
further details.
Condition 2: The display resolution and frequency of the computer must be listed
in the "Appendices - List of Supported Signal Resolutions".
Some computers may have functions for changing the output resolution. For details, refer
to the section of the documentation provided with your computer and change the setting to
within a range given in the list of supported resolutions.
11
Turn off the power for both the projector and the computer before connecting them. If
the power for either device is on at the time of connection, damage may result.
Check the shapes of the cable connectors and the device ports before making the
connections. If you try to force a connector to fit a device port with a different shape
or number of terminals, damage to the connector or port may result.
You may need to purchase a separate adapter to connect the
computer to the projector, depending on the shape of the computer's
monitor port. For details, refer to the section of the documentation
provided with your computer.
The commercially available adapter set is required in order to connect
the projector to a Macintosh computer.