Epson Home Cinema 2100 조립 지침 - 페이지 7

{카테고리_이름} Epson Home Cinema 2100에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Home Cinema 2100 13 페이지. Ink system eco-flo continuous ink system permajet
Epson Home Cinema 2100에 대해서도 마찬가지입니다: 빠른 설정 (4 페이지)

페이지 인쇄

This process is carried out by inserting the 10ml syringe and

wing adaptor at the base of the injector. PLEASE ENSURE THAT

THE WING ADAPTOR (TIP ONLY) IS GENTLY INSERTED

INTO THE BASE OF THE INJECTOR, DO NOT push the tip any further

than 3mm (see diagram opposite) otherwise this will split the base of the

injector.

PLEASE ENSURE that you DOUBLE CHECK that the correct tube is

located to the correct ink bottle before pulling back on the syringe (see Fig.11).

At this point LOCK the tube with the white clamp see Fig.12 before

removing the syringe from the bottom base of the injector to avoid any

air travelling in the injector.

Any ink remaining in the syringe can be put back into the correct ink bottle. MAKE SURE you wash the syringe with

warm water ready for the next colour to be primed. Repeat this process for all the inks so that you finish up with a

set of injectors and tubes full of ink as illustrated in Fig.13.

Fig.11

Step 9 Install Chip Block & Injectors

Please place the Chip block as indicated in Fig.14 below making sure that this is correctly positioned & installed.

Once you have installed this you are ready to insert the set of 7 injectors in the printer carriage.

Priming an

Ink tube being

Injector

Fig.13

clamped

Diagram showing

the wing adaptor tip

only inserted gently

in the base of the

injector.

Fig.12