Cisco N540X-8Z16G-SYS-A 매뉴얼 - 페이지 23

{카테고리_이름} Cisco N540X-8Z16G-SYS-A에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco N540X-8Z16G-SYS-A 30 페이지.
Cisco N540X-8Z16G-SYS-A에 대해서도 마찬가지입니다: 설치 준비 (14 페이지)

페이지 인쇄

Install the Device

Note

To connect cables to the system management port, attach Category 5 cables directly to the RJ-45 receptacle

on the management Ethernet port.

Note

• Plug the cable directly into the RJ-45 receptacle.

• Connect the network end of your RJ-45 cable to a switch, hub, repeater, or other external equipment.

Connecting Timing Cables

The sections below describe how to connect timing cables to the Cisco NCS 540 Small Density Router.

Note

Connecting Cables to a GPS Interface

The following sections describe how to connect cables from the Cisco NCS 540 Small Density router to a

GPS unit for input or output timing:

Connecting a Cable to the Input 10-MHz or 1-PPS Interface

1. Connect one end of the mini-coax cable to the external GPS unit or any other equipment that is provided

with stable 1PPS/10M reference input.

To prevent an IP address conflict, do not connect the management Ethernet port until the initial

configuration is complete.

To comply with GR-1089-CORE, the intra-building port(s) of the equipment must use shielded

intra-building cabling or wiring that is grounded at both ends.

The timing features are not applicable to Cisco N540-6Z18G-SYS-A/D router.

Connecting Timing Cables

Install the Device