Cisco N540X-8Z16G-SYS-A Руководство - Страница 23

Просмотреть онлайн или скачать pdf Руководство для Сетевой маршрутизатор Cisco N540X-8Z16G-SYS-A. Cisco N540X-8Z16G-SYS-A 30 страниц.
Также для Cisco N540X-8Z16G-SYS-A: Подготовка к установке (14 страниц)

Печатать страницу

Install the Device

Note

To connect cables to the system management port, attach Category 5 cables directly to the RJ-45 receptacle

on the management Ethernet port.

Note

• Plug the cable directly into the RJ-45 receptacle.

• Connect the network end of your RJ-45 cable to a switch, hub, repeater, or other external equipment.

Connecting Timing Cables

The sections below describe how to connect timing cables to the Cisco NCS 540 Small Density Router.

Note

Connecting Cables to a GPS Interface

The following sections describe how to connect cables from the Cisco NCS 540 Small Density router to a

GPS unit for input or output timing:

Connecting a Cable to the Input 10-MHz or 1-PPS Interface

1. Connect one end of the mini-coax cable to the external GPS unit or any other equipment that is provided

with stable 1PPS/10M reference input.

To prevent an IP address conflict, do not connect the management Ethernet port until the initial

configuration is complete.

To comply with GR-1089-CORE, the intra-building port(s) of the equipment must use shielded

intra-building cabling or wiring that is grounded at both ends.

The timing features are not applicable to Cisco N540-6Z18G-SYS-A/D router.

Connecting Timing Cables

Install the Device