Cisco NCS 6008 포장 풀기, 이동 및 고정 매뉴얼 - 페이지 40

{카테고리_이름} Cisco NCS 6008에 대한 포장 풀기, 이동 및 고정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco NCS 6008 44 페이지. 6000 series network convergence system routers unpacking, moving, and securing guide
Cisco NCS 6008에 대해서도 마찬가지입니다: 매뉴얼 (12 페이지)

페이지 인쇄

Moving the Unpacked Chassis

Steps

With a person on each side of the chassis, turn all four lifting cranks of the dolly slowly clockwise. Lift

Step 1

the dolly to the "Transport" marking on the height label on each lift assembly leg. The dolly can be used

to transport the chassis at heights from 0.5 to 3.0 inches; the transport height is 1 inch max and 1.5 inch

max for going over thresholds.

Note

Unlock the dolly caster anti-rotation and brake systems.

Step 2

Note

Use at least three people to transport the chassis up any ramp. Position one person in the front of the

Step 3

chassis to pull, one person at the rear of chassis to push, and one person steering the chassis.

Carefully roll the chassis into position near its mounting location.

Step 4

Cisco Network Convergence System 6000 Series Routers Unpacking, Moving, and Securing Guide

3-6

The dolly has four separate lifting cranks, each of which works independently. It is best to turn

each lifting crank simultaneously when lifting the chassis to keep the chassis as level as possible

so as to not put undue stress on the chassis frame or dolly and to reduce the risk of tipping too far.

The 180-degree position is the recommended configuration for moving the chassis. If needed

because of site requirements, rotate the dolly to the 90-degree position. If you are transporting

in a 90-degree configuration, then have at least two people moving the chassis to prevent any

transporting hazard. See the

further information.

You must lower the chassis completely to the floor before rotating the outrigger legs. When you

have rotated the lifting cranks, raise the chassis again. See the

Configuration" section on page 1-11

The dolly is optimized to move the chassis on flat surfaces. It is not designed to move the chassis

up stairs, over curbs, up ramps, or over bumps more than 1.5 inches high (such as door

thresholds).

"Modifying the Dolly Configuration" section on page 1-11

for further information.

Chapter 3

for

"Modifying the Dolly

OL-29233-01