Cisco Nexus 9000 Series 빠른 시작 구성 매뉴얼 - 페이지 3

{카테고리_이름} Cisco Nexus 9000 Series에 대한 빠른 시작 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Nexus 9000 Series 6 페이지. Switch chassis
Cisco Nexus 9000 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (32 페이지), 구성 매뉴얼 (32 페이지), 매뉴얼 (30 페이지), 설치 매뉴얼 (12 페이지), 설치 (8 페이지), 빠른 시작 매뉴얼 (14 페이지), 매뉴얼 (16 페이지)

페이지 인쇄

Send a Call Home Inventory message to start the registration process

NX-9000#callhome test inventory

trying to send test callhome inventory message

successfully sent test callhome inventory message

Receive an email from Cisco and follow the link to complete registration for Smart Call Home

Call Home Configuration - Email to Smart Call Home

The following is a sample configuration showing the minimum steps required to configure Call Home

on a Nexus 9000 to communicate using email with the Smart Call Home System and a command to start

the registration process.

Set the system contact - In global configuration mode enter the mandatory system contact

using the snmp-server contact command.

NX-9000#config t

NX-9000(config)#snmp-server contact sys-contact

2. Configure the mandatory contact information (phone number, email address, & street address)

NX-9000(config)#callhome

NX-9000(config-callhome)#email-contact email-address

NX-9000(config-callhome)#phone-contact +1-000-000-0000

NX-9000(config-callhome)#streetaddress a-street-address

3. Configure the mandatory email server information and from email address - The server address

is an IPv4 address, IPv6 address or domain-name of a SMTP server that Call Home will send

email messages to. Optional port number (default = 25) and VRF may also be configured.

NX-9000(config-callhome)#transport email smtp-server ip-address port 25 use-vrf vrf-name

NX-9000(config-callhome)#transport email from email-address

4. Set the destination profile CiscoTAC-1 email-address to [email protected] -

NX-9000(config-callhome)#destination-profile CiscoTAC-1 email-addr [email protected]

5. Set the periodic inventory interval to 30 days -

NX-9000(config-callhome)#periodic-inventory notification interval 30

6. Send a Call Home Inventory message to start the registration process -

NX-9000#callhome test inventory

trying to send test callhome inventory message

successfully sent test callhome inventorymessage

Receive an email from Cisco and follow the link to complete registration for Smart Call home.