Cisco Nexus 9000 Series 빠른 시작 구성 매뉴얼 - 페이지 5
{카테고리_이름} Cisco Nexus 9000 Series에 대한 빠른 시작 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Nexus 9000 Series 6 페이지. Switch chassis
Cisco Nexus 9000 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (32 페이지), 구성 매뉴얼 (32 페이지), 매뉴얼 (30 페이지), 설치 매뉴얼 (12 페이지), 설치 (8 페이지), 빠른 시작 매뉴얼 (14 페이지), 매뉴얼 (16 페이지)
페이지 인쇄
Call Home Configuration - Email to Transport Gateway and HTTPS to Cisco
The following is a sample configuration showing the minimum steps required to configure Call Home
on a Nexus 9000 to communicate, via a Transport Gateway, with the Smart Call Home System using
HTTPS and a command to start the registration process. The TG will use HTTPS to communicate with the Smart
Call Home System. This assumes that the
Smart Call Home.
1. Set the system contact - In global configuration mode enter the mandatory system contact
using the snmp-server contact command.
NX-9000#config t
NX-9000(config)#snmp-server contact sys-contact
2. Configure the mandatory contact information (phone number, email address, & street address)
NX-9000(config)#callhome
NX-9000(config-callhome)#email-contact email-address
NX-9000(config-callhome)#phone-contact +1-000-000-0000
NX-9000(config-callhome)#streetaddress a-street-address
3. Configure the mandatory email server information and from email address - The server address
is an IPv4 address, IPv6 address or domain-name of a SMTP server that Call Home will send
email messages to. Optional port number (default = 25) and VRF may also be configured.
NX-9000(config-callhome)#transport email smtp-server ip-address port 25 use-vrf vrf-name
NX-9000(config-callhome)#transport email from email-address
4. Set the destination profile CiscoTAC-1 email-address to an email address for the account
that the Transport Gateway will be accessing -
NX-9000(config-callhome)#destination-profile CiscoTAC-1 email-addr email-address
5. Set the periodic inventory interval to 30 days -
NX-9000(config-callhome)#periodic-inventory notification interval 30
6. Send a Call Home Inventory message to start the registration process -
NX-9000#callhome test inventory
trying to send test callhome inventory message
successfully sent test callhome inventorymessage
Receive an em ail from Cisco and follow the link to com plete the registration for Sm art Call hom e.
Transp ort Gatew ay softw are
has been installed, configured and registered with