Cisco Nexus 9000 Series 구성 매뉴얼 - 페이지 20
{카테고리_이름} Cisco Nexus 9000 Series에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Nexus 9000 Series 32 페이지. Switch chassis
Cisco Nexus 9000 Series에 대해서도 마찬가지입니다: 빠른 시작 구성 매뉴얼 (6 페이지), 구성 매뉴얼 (32 페이지), 매뉴얼 (30 페이지), 설치 매뉴얼 (12 페이지), 설치 (8 페이지), 빠른 시작 매뉴얼 (14 페이지), 매뉴얼 (16 페이지)
Configuring an IP ACL
Command or Action
Step 5
vrf vrf-name
Example:
switch(config-device-group)# vrf vrf1
Configuring an IP ACL
Before You Begin
You will need to determine the type of traffic you want to induce into the chain. For more information about
access lists, see The Cisco Nexus 9000 Series NX-OS Security Configuration Guide, Release 7.x.
SUMMARY STEPS
1. configure terminal
2. ip access-list
3. sequence-number {permit | deny} protocol source destination
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Cisco Nexus 9000 Series NX-OS Catena Configuration Guide, Release 7.x
12
• ip access-list acl-name
• IPv6 access-list acl-name
Purpose
• retry-down-count down-count—Specifies the consecutive
number of times the probe must have failed prior to the node
being marked as DOWN.
• retry-up-count up-count—Specifies the consecutive number of
times the probe must have succeeded prior to the node being
marked as UP.
IPv6 probes are not
Note
supported.
(Optional)
Configures VRF for a device group.
Purpose
Enters global configuration mode.
Configuring the Catena Solution