CAB 5326C 조립 지침 매뉴얼 - 페이지 10
{카테고리_이름} CAB 5326C에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAB 5326C 15 페이지. Vacuum-belt applicator
페이지 인쇄
4
Adjustments
10
Note!
i
The alignment of the applicator to the printer is set to the factory standard and should not be altered to
ensure reliable label transportation. Only the Angle to the printer as well as the pinch roller should be
adjusted.
4.1
Setting the Angle to the Printer
1
Fig. 5
Downward angle of the applicator to the printer
Warning!
!
Be aware when you loosen the screws (1)! The device will drop due to its own weigh.
Loosen screws (1) to adjust the angle and so the distance between printer and pinch roller.
Place a product and adjust the angle of the device. Tighten screws (1) .
4.2
Settings within the Setup of the Printer
The configuration parameters of the applicator can be found in the menu Setup > Machine param.
Speed
Note!
i
The speed of the belt and the label transport speed can be set via the parameter Support del. off.
The value is displayed in ms and not, the actual value used, mm/s.
Note!
i
It's necessary to set the exact the values visible in the table.
In case of a deviations the standard value of 100 will be used.
Parameter to set the speed of the belts.
The four available values are:
100 ms :
150 ms :
220 ms :
300 ms :
500 ms :
> > Support del. off
100 mm/s speed of the transport belt
150 mm/s speed of the transport belt
220 mm/s speed of the transport belt
300 mm/s speed of the transport belt
500 mm/s speed of the transport belt
max 30°
10