CAB 5326C 조립 지침 매뉴얼 - 페이지 12

{카테고리_이름} CAB 5326C에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAB 5326C 15 페이지. Vacuum-belt applicator

Operation

5.1

Before commencing the labeling process check that the underlying connection are active.

 Load material. Ensure that the locking system is locked  "Operator's Manual" of the printer.

 Switch on the printer.

 Press the feed key at the printer.

A synchronization feed is initiated. The processed labels need to be removed manually. After a few seconds the

printer carries out a short back feed to position the front edge of the next label at the printing line.

Note!

This synchronizing also has to be carried out when the print job has been interrupted with the cancel key.

Synchronizing is not necessary when the print head was not lifted between print jobs. This also applies if

the printer was powered off between print jobs.

 Start a print job

 Start the labelling process via PLC interface.

Error messages during labelling process are shown in the display of the printer  Error Messages.

5.2

Attention!

Never use solvent and abrasive.

Fig. 7

Cleaning

 Clean the outside surfaces and

 Clean the fan area with a soft brush

 Use glass cleaner to clean the reflex

 To clean the pressure roller use a

transport belts with multi purpose

cleaner: Area 1

and/or a vacuum cleaner: Area 2

sensor: Area 3

special roller cleaner: Area 4