CAB 5326C Instrukcja montażu - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Urządzenia przemysłowe CAB 5326C. CAB 5326C 15 stron. Vacuum-belt applicator

Operation

5.1

Before commencing the labeling process check that the underlying connection are active.

 Load material. Ensure that the locking system is locked  "Operator's Manual" of the printer.

 Switch on the printer.

 Press the feed key at the printer.

A synchronization feed is initiated. The processed labels need to be removed manually. After a few seconds the

printer carries out a short back feed to position the front edge of the next label at the printing line.

Note!

This synchronizing also has to be carried out when the print job has been interrupted with the cancel key.

Synchronizing is not necessary when the print head was not lifted between print jobs. This also applies if

the printer was powered off between print jobs.

 Start a print job

 Start the labelling process via PLC interface.

Error messages during labelling process are shown in the display of the printer  Error Messages.

5.2

Attention!

Never use solvent and abrasive.

Fig. 7

Cleaning

 Clean the outside surfaces and

 Clean the fan area with a soft brush

 Use glass cleaner to clean the reflex

 To clean the pressure roller use a

transport belts with multi purpose

cleaner: Area 1

and/or a vacuum cleaner: Area 2

sensor: Area 3

special roller cleaner: Area 4