CAB 5946091 운영자 매뉴얼 - 페이지 7

{카테고리_이름} CAB 5946091에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAB 5946091 10 페이지. External unwinder eu4 for thermal transfer printer a3/a4/m4

Retaining Rolls with 3 in ( 76 mm) Cardboard Core on the Winding Axle

NOTICE !

Before mounting the winding axle read this chapter and "Insertion of the

prepared Winding Axle" and attend on the running of the media in dependence

to inside and outside wound label rolls.

NOTICE !

For rolls with 3 in ( 76 mm) cardboard core you have to mount the winding

adapter on the flanges and remove the spring from the winding axle as

described in "Preparing the Winding Axle and the Flanges".

Fig. 6 Mounting the winding axle

Now you can mount the winding axle on the unwinder:

Slide the flange (3a) on the winding axle (2) so that the attachment of the

flange points to the outside.

Align the flange (3a) so that the screw (10) grasps into the groove (11) of

the winding axle (2). Tighten the screw (10) in the flange.

Slide the material roll (12) onto the axle until it touches the flange slightly.

Push the second flange (3b) with the attachment outside onto the axle

until it touches the material roll. The cardboard core of the material roll

has to be positioned on the winding adapters.

Tighten the knurled screw (13) in the flange (3b).

3b 13