CAB MAESTRO 4S 운영자 매뉴얼 - 페이지 12

{카테고리_이름} CAB MAESTRO 4S에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAB MAESTRO 4S 20 페이지. Pcb separator

Operation

If the device switched of an d on it' will start in the last program before switched off.

Switch on the device by the power-switch (1). LED not ready blinking.

Fig.8

Power Switch

1. Press button home.

2. Press the foot-switch and hold it.

- Device will run to the start position or from the start position short out and back into the start position..

- Synchronization of the blades.

3. Deblock the foot-switch - device is ready for operation. LED not ready don't glow.

4. Select program. If you switch of and on, the last used program is selected. After first switch on program 1 is

selected.

5. Put in the PCB panel.

Pre-scored groove in the PCB (2) put onto the linear blade (3) and hold the PCB in the horizontal plane by hand.

Ensure that the PCB is positioned within the area between the green knurled screws, the pre-selected area of

cutting way of the upper blade.

Fig.9

Put in PCB

6. Press the foot-switch to start the program. Foot-switch must be pressed over the length of the program.

7. Deblock the foot-switch after program end.

Notice!

In case of uneven number of cuts will be an other start position for the next program start.

Reset the display of cut length

 Press button DEL for 3 seconds.

Display mileage blinking.

 In the next 3 seconds press button DEL again to reset the display to Zero.