Cisco Soho 78 빠른 시작 매뉴얼 - 페이지 3
{카테고리_이름} Cisco Soho 78에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Soho 78 11 페이지. Cisco 828 router and soho 78 router cabling and setup quick start guide
Cisco Soho 78에 대해서도 마찬가지입니다: 데이터시트 (9 페이지)
페이지 인쇄
Connecting a Hub
This section describes how to connect a hub to the router Ethernet 4 port.
The TO HUB/TO PC button identifies the device that you connect to the yellow Ethernet 4 port, using
the yellow Ethernet cable. For example, setting the button to the TO HUB position (in) indicates that you
are connecting a hub; setting the button to the TO PC position (out) indicates that you are connecting a
server, PC, or workstation. For information on how the settings of this button on a hub can affect the
setting of this router, refer to the Cisco 828 Router and SOHO 78 Router Hardware Installation Guide.
You can use the yellow Ethernet cable to connect a server, PC, or workstation to any of the four Ethernet
ports. However, if you want to connect a hub to a port other than the ETHERNET 4 port, you must use
a crossover cable, which is not included with the router.
To connect a hub to the router, follow the steps in
Figure 2
2. Connect yellow cable
to ETHERNET 4 port
on Cisco 828 or
SOHO 78 router.
Note
To connect a hub to an Ethernet port other than the ETHERNET 4 port, you must use a crossover
cable, which is not included with your router.
78-12839-01
Connecting a Hub
1. Set TO HUB/TO PC button.
TO HU B
ET HE RN
TO PC
ET 10 BA
4
3
Cisco 828 Router and SOHO 78 Router Cabling and Setup Quick Start Guide
Figure
2.
Cisco 828 router
M o d e l C
is c o 8 2 8
SE T
CO NS OL
E
G. SH DS
L
+5 VD C
2
1
Cisco 1528 Micro Hub 10/100
1X
2X
SP EE D
10 0B as
LE D
eT X
SO LI D
1
10 Ba se
2 3 4
T
BL IN K
5 6 7
8
3. Connect other
end of cable
to hub.
Connecting Cables to the Router
ET HE
RN ET
3X
4X
6X
7X
8X
MD I
MD I-X
4. If applicable, check
setting of hub
equivalent of router
TO HUB/TO PC button.
3