CAB ST4 Series 운영자 매뉴얼 - 페이지 10

{카테고리_이름} CAB ST4 Series에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAB ST4 Series 16 페이지. Stacker with cutter

Installation

2.4

Adapting the Stacker to the Media Size

Caution!

Risk of injury!

With inappropriate tables and safety covers the reliability and machinery safety cannot be guaranteed.

 Equip the stacker only with a table designated for the media to be used and the matching safety covers.

2.4.1

Figure 7

 At ST4/L adjust side plate (4) only.

 At ST4/M adjust both side plates (4,5).

For it :

1. Loosen screws (2).

2. Adjust the side plates (4,5) to the media width using the scale (1). Use the edges (3) of the side plates as

pointers.

3. Tighten screws (2).

2.4.2

Figure 8

1 2 3 4

ST4/L

Adjusting the Side Plates

Mounting the table

1 2

1. Loosely screw the knurled nuts (3) contained in the

delivery contents of the table onto the threaded pins (2).

2. Insert the threaded pins of the table (1) into the holes of

the retainer (4) an move the table to the printer until it

stops.

3. Tighten the knurled nuts (3).

3 4

ST4/M