Cisco UBR7246VXR 빠른 시작 매뉴얼 - 페이지 9
{카테고리_이름} Cisco UBR7246VXR에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UBR7246VXR 27 페이지. Universal broadband router
Cisco UBR7246VXR에 대해서도 마찬가지입니다: 사용자 설명서 (7 페이지), 설치 매뉴얼 (28 페이지), 하드웨어 설치 (25 페이지)
페이지 인쇄
Attach the Rack-Mount Brackets to the Rear of the Chassis
To install the rack-mount brackets on the chassis for a rear rack-mount configuration, complete the following steps:
Locate the threaded holes in the rear sides of the chassis.
Step 1
Align the first rack-mount bracket to the threaded holes in the right side of the chassis. See Figure 4.
Step 2
Figure 4
Installing the Rack-Mount Brackets on the Rear of the Chassis
Rack-mount
bracket
There are eight holes in each of the rack-mount brackets for the Cisco uBR7246VXR. You may use either set
Note
of four holes to align the bracket to the threaded holes in the sides of the chassis.
Thread the four M4 x 6-mm Phillips flathead screws through the rack-mount bracket and into the side of the chassis.
Step 3
Use a number 2 Phillips screwdriver to tighten the screws.
Step 4
Repeat Step 1 through Step 3 for the other rack-mount bracket.
Step 5
See the "Installing the Cable-Management Brackets" section on page 11 for cable management bracket instructions.
Attach the Rack-Mount Brackets to the Front of the Chassis
To install the rack-mount brackets on the chassis for a front rack-mount configuration, complete the following steps.
Locate the threaded holes in the front sides of the chassis.
Step 1
Step 2
If you want the front of the chassis flush with the front of the rack, align the first rack-mount bracket to the threaded
holes in the right side of the chassis as shown in Figure 5
If you want the front of the chassis protruding from the rack, align the first rack-mount bracket to the threaded holes
in the right side of the chassis as shown in Figure 6.
There are eight holes in each of the rack-mount brackets. You may use either set of four holes to align the bracket to
Note
the threaded holes in the sides of the chassis.
Thread the four M4 x 6-mm Phillips flathead screws through the bracket and into the side of the chassis. Use a
Step 3
number 2 Phillips screwdriver to tighten the screws.
Step 4
Repeat Step 1 through Step 3 for the other rack-mount bracket.
Rack-mount
bracket
9