Cisco Unified Communications Manager 8.5(1) 빠른 시작 매뉴얼 - 페이지 8
{카테고리_이름} Cisco Unified Communications Manager 8.5(1)에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Unified Communications Manager 8.5(1) 20 페이지. 850 series and 870 series access routers cabling and setup
Cisco Unified Communications Manager 8.5(1)에 대해서도 마찬가지입니다: 데이터시트 (8 페이지)
페이지 인쇄
- 1. Table of Contents
- 2. Cisco One-Year Limited Hardware Warranty Terms
- 3. Locate the Product Serial Number
- 4. Before Installation
- 5. Connect the Antenna to the Wireless Router (Optional)
- 6. Connect the Power-Over-Ethernet Module to the Cisco 870 Series Router (Optional)
- 7. Typical Installations of the Cisco 850 Series and Cisco 870 Series Routers
- 7. Console Port
- 7. Power Adapter
- 8. Connect the Router
- 9. Install SDM and Configure the Router
- 10. Related Documentation
- 11. Obtaining Documentation and Submitting a Service Request
Chapter 1
Connect the Antenna to the Wireless Router (Optional)
Figure 1-4
Cisco 871 Wireless Router with Two Antennas
SN: XXXNNNNXXXX
1
LEFT
0
FE0
Step 1
Step 2
Cisco 850 Series and Cisco 870 Series Access Routers Cabling and Setup Quick Start Guide
1-8
Cisco 850 Series and Cisco 870 Series Access Routers Cabling and Setup Quick Start Guide
LAN
FE1
FE2
FE3
To connect the antenna or antennas to a wireless router, follow these steps:
Attach each antenna to a reverse-polarity threaded Neill-Concelman (RP-TNC)
connector on the back of the router and tighten the connector hand-tight.
After you connect the antenna to the back of the router, orient the antenna so that
it is straight up.
Cisco 871W
WAN
CONSOLE
RESET
AUX
FE4
RIGHT / PRIMARY
+5,+12 VDC
78-16262-04