CABAC HNS050MD 소유자 매뉴얼

{카테고리_이름} CABAC HNS050MD에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CABAC HNS050MD 4 페이지. Motion detector 3-wire

페이지 인쇄

HNS050MD

OWNER'S MANUAL

1. FEATURES

• Switch the light ON touch free

• If the room is dark (<20 lux) and the HNS050MD is connected to a Cabac S-Click timer, movement will trigger

it to turn the light ON for a programmed amount of time

• Ideal for spaces with natural light such as meeting rooms, hallways, offices, laundries and garages

• Detects motion up to 2m from the sensor

• Must be used with Cabac S-Click range of 2-Wire or 3-Wire Timer Switches

• Turns lights ON only in low light conditions - saving power

• Timer switch remains usable as normal

• Uses timer switch to control time

• Extremely low <100 mW standby power consumption

• Compatible with HPM and Clipsal wall plates – lenses included

• 3-Wire requires neutral

2. OPERATING CONDITIONS

• Operating Voltage:

• Operating Temperature:

• Certified Standards:

• Maximum Load:

Note: Operation at temperature, voltage or load outside of the specifications may cause permanent damage to the unit.

3. COMPATIBLE SWITCHES

The HNS050MD must be used with one of the timer switches listed below. It cannot be used on its own.

• HNS410TM Minute Timer 2-Wire

• HNS420TM Hourly Timer 2-Wire

• HNS440TM Minute Timer 3-Wire

• HNS450TM Hourly Timer 3-Wire

4. OPERATION

The HNS050MD is a combination of passive infra-red motion and light level detector that detects motion up to

2m from the sensor. The HNS050MD is a sensor and if the room is dark (<20lux) will trigger the Cabac S-Click

timer to turn the light ON at the first instance of movement for a fixed amount of time - offering both hands

free switching and power savings. See Section 3 for compatible products.

When the HNS050MD detects motion in a darkened room or hallway it will trigger the connected timer switch.

The room or hallway needs to be fairly dark before the sensor will trigger the timer and turn the light ON. The

light can always be turned on directly at the timer switch. The length of time the light stays on is set on the

timer switch.

When used with the HNS410TM or HNS420TM timers, the lights will flash briefly about 1 second after motion is

detected, before turning on for the set timing period.

Note: This manual was correct at the time of manufacture. For the latest version of the manual and any technical or

safety updates refer to the website:- cabac.com.au, cabac.co.nz or scan the QR code with a mobile phone.

Customer Care Australia P: 133 122 F: 1300 303 310 E: [email protected] W: cabac.com.au

A: 8 Distribution Pl, Seven Hills NSW 2147

Customer Care New Zealand P: 8 0077 6969 F: 8 0088 6969 E: [email protected] W: cabac.co.nz

HNS050MD MOTION DETECTOR 3-WIRE

Scan our QR code

with your phone to go

directly to our website

for technical information

220 – 240Va.c. 50Hz

0 to +50°C

CISPR15, AS/NZS 3100

As per connected Cabac Timer Switches

REQUIRES

CABAC TIMER

SWITCH

CP14117 Rev 1, 24

APRIL 2015