CABAC HNS050MD 소유자 매뉴얼 - 페이지 4

{카테고리_이름} CABAC HNS050MD에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CABAC HNS050MD 4 페이지. Motion detector 3-wire

페이지 인쇄

7. IMPORTANT SAFETY WARNINGS

7.1 LOAD REPLACEMENT

• It should be assumed that even when OFF, mains voltage will still be present at the lamp fitting. Mains

power should be disconnected at the circuit breaker before replacing faulty lamps.

7.2 HNS050MD INSTALLATION

• The HNS050MD is to be installed as part of a fixed wire electrical installation. By law such installations

must be made by an electrical contractor or similarly qualified person. Avoid excessive force during

installation.

7.3 LOW READING DURING INSULATION BREAKDOWN TEST

• The HNS050MD is a solid state device. Therefore a low reading may be observed when conducting

Insulation breakdown testing on the circuit.

7.4 CLEANING

• Clean only with a damp cloth. Do not use abrasives or chemicals.

8. TROUBLESHOOTING

8.1 LIGHTS DO NOT TURN ON

• Ensure that the circuit has power by checking the circuit breaker.

• Ensure the lamp(s) is not damaged or broken.

• The room may be too bright - the HNS050MD will not activate if the room is light. Check if HNS050MD

indicator LED light switches on when motion is detected.

• Ensure the HNS050MD is correctly connected to the the Cabac S-Click Timer Switch.

• The HNS050MD may have been damaged and needs to be replaced.

8.2 TIMER HAS POWER BUT MOTION DETECTOR DOESN'T WORK

• The room may be too bright - the HNS050MD will not activate if the room is light.

•

The HNS050MD might not be connected to the timer switch correctly.

• The HNS050MD is obstructed or being interfered with by dirt, furniture or an object.

• A shadow maybe cast over sensor by person or object.

8.3 LIGHTS TURN ON, THEN OFF

• The HNS050MD is retriggering. Check that the room light is not obstructed from the view of the

HNS050MD.

• The light in the room may not be bright enough, which may happen if a person's shadow cast across the

sensor and the room light is not bright enough.

9. WARRANTY AND DISCLAIMER

CABAC warrant the product against manufacturing and material defect from the date of invoice to the initial

purchaser for a period of 12 months. During the warranty period CABAC will replace products that prove

to be defective where the product has been correctly installed and maintained and operated within the

specifications defined in the product data sheet and where the product is not subject to mechanical damage

or chemical attack. The warranty is also conditional on the unit being installed by a licensed electrical

contractor. No other warranty is expressed or implied.

CABAC shall not be liable for any direct, indirect, incidental or consequential damages.

Note: This manual was correct at the time of manufacture. For the latest version of the manual and any technical or

safety updates refer to the website:- cabac.com.au, cabac.co.nz or scan the QR code with a mobile phone.

Customer Care Australia P: 133 122 F: 1300 303 310 E: [email protected] W: cabac.com.au

A: 8 Distribution Pl, Seven Hills NSW 2147

Customer Care New Zealand P: 8 0077 6969 F: 8 0088 6969 E: [email protected] W: cabac.co.nz

HNS050MD MOTION DETECTOR 3-WIRE

CP14117 Rev 1, 24

APRIL 2015