Cabane Classic Adirondack 조립 지침

{카테고리_이름} Cabane Classic Adirondack에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Cabane Classic Adirondack 2 페이지.

Assembly instructions Classic Cabane Adirondack chair

Parts List:

• Seat assembled

• Back assembled

• Front legs

• Arms

Place the assembled Seat on its side on a flat clean surface.

Locate the Front Leg that you will be installing (Right Picture).

Insert a long connector bolt down through the outermost pre-

drilled hole in front leg and align this with the pre-drilled hole

in seat assembly. Install flat washer, lock washer, and nut.

Finger tighten nut onto bolt in Front Leg, then partially install

the other

(2) long connector bolts, washers and nuts, next to the one you

have just installed. Flip the chair over and repeat process for the

other side. Do not tighten at this time.

Hardware:

Step One: Leg Assembly

• (6) long Connector Bolts

• (4) short Connector Bolts

• (10) Flat Washers

• (10) Lock Washers

• (10) Nuts

• (4) Robertson head Screws

• Screw bit