Cisco 1130AG - Aironet - Wireless Access Point 빠른 시작 매뉴얼 - 페이지 15
{카테고리_이름} Cisco 1130AG - Aironet - Wireless Access Point에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1130AG - Aironet - Wireless Access Point 49 페이지. Ieee 802.11a/b/g access point
Cisco 1130AG - Aironet - Wireless Access Point에 대해서도 마찬가지입니다: 데이터시트 (13 페이지)
페이지 인쇄
Connecting Power
Connect the 1130AG series access point to a power source. The access point
can be powered locally by using an AC power module or over the Ethernet
using power sourcing equipment (PSE). Regardless of the method you use,
the power source must be compliant with the IEC60950 standard for a limited
power source. IEC60950 devices include:
•
An AC power module connected to the access point's power connector
•
The following devices that provide Power-over-Ethernet (PoE):
– An IEEE 802.3af compliant power source
– A compliant Cisco inline power switch
– A Cisco power injector with a compliant AC power module
Caution
If the access point receives power through PoE, the output
current of the PSE cannot exceed 400 mA or 154000/Vport,
whichever is smaller. The power source must comply with
IEC60950. IEEE 802.3af compliant PSEs are compliant with
IEC60950.
When power is supplied to the access point, a routine power-up sequence
begins which you can monitor by observing the access point status LED.
During the power up sequence the LED displays a series of colors. When the
Quick Start Guide Cisco Aironet 1130AG Access Point
15