Cisco 700 series 개요 - 페이지 6

{카테고리_이름} Cisco 700 series에 대한 개요을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 700 series 19 페이지. Using profiles
Cisco 700 series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (8 페이지), 시작하기 매뉴얼 (27 페이지), 사용자 설명서 (9 페이지), 관리 매뉴얼 (36 페이지)

페이지 인쇄

Product Features

again every 30 seconds for as long as the connection exists. If the connection does not exist,

no RIP data is sent. This prevents the line from being brought up by RIP packets where the

update is periodic.

Force Dynamically Negotiated IP Addresses

When this feature is on, the negotiated IP address is assigned to the Standard or the

user-deﬁned proﬁle (whichever proﬁle is used to place the call). It also tells the software to

try any IP address conﬁgured for this proﬁle in the IP address negotiation.

When this feature is off and the internal proﬁle does not contain an address, the negotiated

IP address is automatically assigned to the Internal proﬁle by the system. If the Internal

proﬁle contains an address, it will be assigned to the user-deﬁned proﬁle from which the

call was initiated. The parameters are set using the set ppp address negotiation command.

Fee Pulse Mode

Fee Pulse Mode manages the ISDN connection based on the paid periods of time. If other

thresholds indicate a call should be dropped due to low trafﬁc, Fee Pulse Mode maintains

the connection until the current paid period has expired. Therefore, you are not paying full

price for part of a connection period. This feature is available only for NET3 (same as

ETSI) switch types, and you must subscribe to Advice of Charge-During Active Call

(AOC-D) supplementary service.

If the feature is enabled and idle time expires, the router checks the remaining time in the

current paid period. The router maintains the connection until the end of the paid period,

minus the disconnect time required to terminate the PPP and ISDN links.

If the idle time expires too close to the end of the paid period to close the connections before

the end of the paid period, the router extends the connection to the end of the next paid

period, minus disconnect time.

Call Transfer

Cisco 700 series routers can transfer an active voice call to another telephone number. For

more information on conﬁguring call transfer, refer to the chapter "ISDN and Analog

Telephone Devices."

1-6 Cisco 700 Series Router Installation Guide