Cisco 7200 VXR Series 빠른 시작 매뉴얼 - 페이지 13

{카테고리_이름} Cisco 7200 VXR Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7200 VXR Series 48 페이지. Preparing for installation
Cisco 7200 VXR Series에 대해서도 마찬가지입니다: 데이터시트 (12 페이지), 매뉴얼 (14 페이지)

페이지 인쇄

Figure 7

Attaching the Rack-Mount Brackets to the Rear of the Chassis—Front Protrudes from the Rack

Rack-mount bracket

M4 x 8-mm Phillips flathead screws

Brackets Rear-Mounted—Front Protrudes from the Rack

Step 1

Locate the threaded screw holes in the rear sides of the chassis.

Step 2

Align a rack-mount bracket (1) to the threaded holes in the right side of the chassis.

Step 3

Using a Number 2 Phillips screwdriver and two M4 x 8-mm Phillips flathead screws (2), attach the rack-mount bracket

to the router.

Step 4

Repeat Steps 2 and 3 for the bracket on the other side of the router. If you are not installing cable-management brackets,

skip to the "Two-Post or Four-Post Rack Installation" section on page 13 for rack-mount instructions. Otherwise,

continue with Step 5.

Step 5

Align a cable-management bracket (3) to the threaded holes in the front of the chassis.

Step 6

Using two M4 x 8-mm Phillips flathead screws (4), thread and tighten the screws through the cable-management

bracket and into the chassis.

Step 7

Repeat Step 5 and Step 6 on the other side of the router.

If you have an NPE-G1 or NPE-G2 installed, go to the "NPE-G1 or NPE-G2 Rear Cable-Management Brackets on a

Rear-Mounted Router" section on page 15, or the "NPE-G1 or NPE-G2 Optical Cable-Management Bracket" section on

page 16.

If you do not have an NPE-G1 or NPE-G2 installed, go to the "Two-Post or Four-Post Rack Installation" section on page 16.

Cisco 7200

Series

TOKEN RING

ETHERNET 10BT

ETHERNET-10BFL

FAST ETHERNET INPUT/OUTPUT CONTROLLER

Cable-management bracket

M4 x 8-mm Phillips flathead screws