Cisco 7200 VXR Series 빠른 시작 매뉴얼 - 페이지 11

{카테고리_이름} Cisco 7200 VXR Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7200 VXR Series 48 페이지. Preparing for installation
Cisco 7200 VXR Series에 대해서도 마찬가지입니다: 데이터시트 (12 페이지), 매뉴얼 (14 페이지)

페이지 인쇄

Figure 5

Attaching the Rack-Mount Brackets to the Front of the Chassis—Chassis Recessed

Cisco 7200

Series

Cable-management bracket

Rack-mount bracket

Brackets Front-Mounted—Chassis Recessed in Rack

Locate the rack-mount and cable-management brackets and screws and a Number 2 Phillips screwdriver.

Step 1

Align the cable-management bracket (1) to the side of the router. Align the rack-mount bracket over it—as shown

above—and insert and tighten the screws (3).

Go to the "Two-Post or Four-Post Rack Installation" section on page 16.

Step 2

If you are not using the cable-management brackets, align the rack-mount brackets (2)—as shown above—to the router

and insert and tighten the screws.

If you have an NPE-G1 or NPE-G2 installed, go to the "NPE-G1 and NPE-G2 Rear Cable-Management Brackets on a

Front-Mounted Router" section on page 12.

If you do not have an NPE-G1 or NPE-G2 installed, go to the "Two-Post or Four-Post Rack Installation" section on page 16.

ETHERNET 10BT

TOKEN RING

ETHERNET-10BFL

FAST ETHERNET INPUT/OUTPUT CONTROLLER

M4 x 8-mm Phillips flathead screws