Cisco 800 Series 디자인 매뉴얼 - 페이지 43

{카테고리_이름} Cisco 800 Series에 대한 디자인 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 800 Series 50 페이지. Fast step software design guide
Cisco 800 Series에 대해서도 마찬가지입니다: 릴리스 정보 (36 페이지), 빠른 시작 매뉴얼 (13 페이지), 빠른 시작 매뉴얼 (17 페이지), 구성 (32 페이지)

페이지 인쇄
Cisco 800 Series 디자인 매뉴얼
Chapter A
Additional Flags and Parameters
PasswordRCN
PrimaryDNSAddressOnE0
PrimaryWINSAddressOnE0
ReadonlyPassword
RemotePhoneNumberISP1,
RemotePhoneNumberISP2,
RemotePhoneNumberRCN1,
RemotePhoneNumberRCN2
RouterName
SecondaryDNSAddressOnE0
SecondaryWINSAddressOnE0
ServiceProviderURL
SetAdjustPCStackSettings
SetRouterAsDHCPServerOnE0
SetRouterToDefaultConfig
OL-10373-02
Password for a PPP connection to a remote corporate
network.
Primary Domain Name System (DNS) address used to
configure the clients with the required DNS address
when the router is being used as a DHCP server. (See also
SecondaryDNSAddressOnE0.)
Primary WINS address used to configure the clients with
the required WINS address when the router is being used
as a DHCP server. (See also
SecondaryWINSAddressOnE0.)
Read-only password for the router.
Technical support phone numbers displayed in the
Technical Support window.
Name given to the router.
Secondary DNS address used to configure the clients
with the required DNS address when the router is being
used as a DHCP server. (See also
PrimaryDNSAddressOnE0.)
Secondary WINS address used to configure the clients
with the required WINS address when the router is being
used as a DHCP server. (See also
PrimaryWINSAddressOnE0.)
Technical support Web site for the Technical Support
pop-up window.
Router connection type. If the value is blank or 0, the
console cable connection is used, and the PC stack
settings are not changed. If the value is 1, the network is
used to configure the router.
Configures the router as a DHCP server on the LAN. If
the value is 0 or blank, the PC is also configured as a
DHCP client, so it can communicate with the router. If
this flag is set to 1 and the
SetForceStaticAddressOnPCAlways flag is set to 1, this
flag is given preference.
Sets the router to the factory default configuration. When
this flag is enabled, the Erase Configuration window is
skipped. Enabled = 1. Disabled (default) = 0.
Cisco 800 Fast Step Software Design Guide
A-3