Cisco AIR-AP1010 - 1000 Series Lightweight Access Point 빠른 시작 매뉴얼 - 페이지 15
{카테고리_이름} Cisco AIR-AP1010 - 1000 Series Lightweight Access Point에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco AIR-AP1010 - 1000 Series Lightweight Access Point 36 페이지. Aironet 1000 series ieee 802.11a/b/g lightweight access points with internal antennas
페이지 인쇄
Installation and Configuration
•
•
•
•
•
•
Continue with
Pre-Installation Configuration
The following procedures are designed to ensure that your AP installation and initial operation go as
expected. If you are unable to prepare your AP for deployment, this section also describes RMA (Return
Material Authorization) procedures.
Perform the following procedure on each AP BEFORE deploying it in its final location.
Note
This procedure assumes that you are preparing a version 3.0 or later APs to operate with a Cisco Wireless
Note
LAN Controller.
Configuration Setup
The figure below explains the configuration setup.
Figure 1
onfiguration Setup
7817146-01
Optional AC-to-DC external power supplies, factory-orderable. Note that this option requires the
power cable to be run through the plenum in a metal conduit to meet safety requirements.
Map showing APs locations and mounting and power options.
Screwdrivers, drills, and ladder.
An assortment of sheet metal and drywall screws and toggle bolts.
CAT-5 (or higher) cables to connect the AP locations and other network devices.
Optional Kensington MicroSaver Security Cable to secure each AP.
"Pre-Installation
Configuration Setup
AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal
Configuration".
Controller
Layer 2/3
devices
Access
points
Pre-Installation Configuration
3