Cisco AIR-AP1010 - 1000 Series Lightweight Access Point Посібник із швидкого старту - Сторінка 15
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Бездротова точка доступу Cisco AIR-AP1010 - 1000 Series Lightweight Access Point. Cisco AIR-AP1010 - 1000 Series Lightweight Access Point 36 сторінок. Aironet 1000 series ieee 802.11a/b/g lightweight access points with internal antennas
Друкувати сторінку
Installation and Configuration
•
•
•
•
•
•
Continue with
Pre-Installation Configuration
The following procedures are designed to ensure that your AP installation and initial operation go as
expected. If you are unable to prepare your AP for deployment, this section also describes RMA (Return
Material Authorization) procedures.
Perform the following procedure on each AP BEFORE deploying it in its final location.
Note
This procedure assumes that you are preparing a version 3.0 or later APs to operate with a Cisco Wireless
Note
LAN Controller.
Configuration Setup
The figure below explains the configuration setup.
Figure 1
onfiguration Setup
7817146-01
Optional AC-to-DC external power supplies, factory-orderable. Note that this option requires the
power cable to be run through the plenum in a metal conduit to meet safety requirements.
Map showing APs locations and mounting and power options.
Screwdrivers, drills, and ladder.
An assortment of sheet metal and drywall screws and toggle bolts.
CAT-5 (or higher) cables to connect the AP locations and other network devices.
Optional Kensington MicroSaver Security Cable to secure each AP.
"Pre-Installation
Configuration Setup
AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal
Configuration".
Controller
Layer 2/3
devices
Access
points
Pre-Installation Configuration
3