Cisco AIR-AP1010 - 1000 Series Lightweight Access Point 빠른 시작 매뉴얼 - 페이지 22
{카테고리_이름} Cisco AIR-AP1010 - 1000 Series Lightweight Access Point에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco AIR-AP1010 - 1000 Series Lightweight Access Point 36 페이지. Aironet 1000 series ieee 802.11a/b/g lightweight access points with internal antennas
페이지 인쇄
Mounting the Access Points
Projection Wall Mount
When you are mounting the AP out from a wall (flat sides along the wall or hallway), use an optional
factory-orderable projection-mount L-bracket.
1.
The AP threaded holes have precision-depth threads. Do not overtighten the screws, or the bracket will
Note
not fit under the screw heads.
Figure 7
2.
3.
4.
Note
If the screws do not securely hold the bracket, remove the AP and adjust the screws until they securely
hold the bracket.
AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal
10
Before proceeding, gently screw the two factory-supplied screws and spring washers into the bottom
of the AP. Be sure the spring washers have their convex (high center sections) pointing toward the
screw heads.
Attaching the Mounting Screws and Spring Washers to the AP
A. Screws and spring washers
Copy the MAC address(es) from the label(s) on the AP onto the corresponding location on the map.
MAC addresses have the format 00xxxxxxxxxx.
You have already attached the projection-mount L-bracket to the wall in
Points".
Slide the screws into the keyhole slots on the mounting bracket as shown in the following figure.
Installation and Configuration
B. Completed assembly
"Mounting the Access
7817146-01