Argent CD20SW0801 빠른 시작 매뉴얼 - 페이지 2
{카테고리_이름} Argent CD20SW0801에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Argent CD20SW0801 2 페이지. Centra range with drawers
페이지 인쇄IMPORTANT:
IT IS NECESSARY TO SECURE THE
CABINET THROUGH THE SOLID
BACK BOARD INTO A SECURE
SUBSTRATE.
FOR CAVITY WALLS, CABINET MUST
BE SECURED THROUGH THE WALL
INTO EITHER WALL STUDS OR
NOGGINS.
FOR SOLID WALLS, SUITABLE WALL
PLUGS/FIXINGS WILL NEED TO BE
USED.
PRIOR TO INSTALLATION
Argent recommends a qualified trade
person fit your bathroom furniture.
Ensure your furniture is installed to
relevant building codes and Australian
Standards.
Please note, Argent will not be liable
for the cost of installation or removal
of the furniture and the warranty will be
voided if damage occurred during or
after installation.
MEASURE & MARK
Fit wall hung basin at required height
to secure stud or frame, ensure level.
(1)
Remove
drawer of cabinet and set
aside carefully.
Locate wall studs to secure cabinet.
Measure and mark fixing positions
for drilling. Fix through multiple studs/
noggins to ensure secure fixing, a
minimum of 6 fixing positions is required.
For solid walls, use fixings appropriate to
your wall substrate. Mark and cut holes
in the cabinet for hot and cold water
inlets and waste exit pipe as required.
See relevant specification sheet for
specific cut outs.
INSTALLATION
Fit the wall hung cabinet to the required
height and location to studs and/or solid substrate, ensure the cabinet is level. The drawer of cabinet can be removed
by pulling the clasps on the underside front towards the outer edge of the drawer. Set the drawer aside carefully.
1
3
2
C
Ensure drawers are adjusted to sit square as
they may have moved during transportation.
Ensure runners are locked in place.
FITTING TAPWARE & WASTE
If tapware and waste are still to be fitted, the drawer of cabinet can be
removed by pulling the clasps on the underside front towards the outer
edge of the drawer. Set the drawer aside carefully. Fit tapware and
waste to the basin.
Test to ensure there are no leaks.
Replace the drawer.
FIT OFF, ADJUST & FINISH
Replace drawer and adjust to ensure all square with the installed vanity.
Put a bead of bathroom grade silicon around the rear edge of the stone
top & or basin where they touch the wall & or the stone top for sealing .
Drawer Release
Feel under the drawer for
release catches. Squeeze
catches, lift up and towards
you to release the drawer from
the runners.
Basin Sealing
I MP OR TA N T:
U S E O N LY b a t h r o o m
g rad e si l i co n s ea l an t
Epoxy type glues
MUST NOT BE USED.
Put a bead of bathroom grade
silicon around the back edge
of the basin and where the
basin touches the wall. Do not
tighten the basin bolts to avoid
damaging the basin.
I M P OR TA N T:
INSPECT THE FURNITURE
TO ENSURE NO DAMAGE
HAS OCCURRED DURING
TRANSIT.
IF DAMAGE HAS
OCCURRED, OR VISIBLE
DEFECTS EXIST, DO
NOT PROCEED WITH
INSTALLATION AND ADVISE
ARGENT IMMEDIATELY.